SCHUNK ADR-C, Assembly And Operating Manual

Page: 27 / 32

Operation
When clamping the product, observe the following points:
• Ensure that the product is clamped by the chuck jaws and not
by the base jaws of the lathe chuck.
• Turn or grind the product in the lathe chuck under the same
clamping force as the subsequent workpiece. Do not exceed the
maximum permissible clamping force
} 3 [
/
13] .
• The flat areas or clamping pins must be in full contact with the
chuck jaws.
For clamping, proceed as follows:
1. Mount the chuck jaws to be turned according to the
specifications in the operating manual of the lathe chuck used.
2. Unclamp the lathe chuck according to the specifications in the
operating manual of the lathe chuck used.
3. If used, ensure that the clamping pins are mounted
correctly
}
5 [
/
15] .
4. Screw the locking pin into the axial thread (only for ADR-C/
ADR-C2).
5. Insert the product into the lathe chuck in the correct position.
NOTE: Make sure that the product (or the clamping pins) is/are
in full contact with the chuck jaws and not with the base jaws
of the lathe chuck!
6. Clamp the lathe chuck according to the specifications in the
operating manual of the lathe chuck used. Do not exceed the
maximum permissible clamping force
}
3 [
/
13] .
7. Remove locking pin (only for ADR-C/ADR-C2).
✓
The product is reliably clamped. The chuck jaws can be
turned.
IMPORTANT! Sharp burrs can occur when turning chuck jaws!
Deburr the chuck jaws after turning!
6.3 Unclamping the product
1. Secure the product against falling.
2. Unclamp the lathe chuck according to the specifications in the
operating manual of the lathe chuck used.
3. Remove the product.
27 02.00 | Jaw turning rings | Assembly and Operating Manual | en | 0189701