Schulte SDX-102, Operator'S Manual

Page: 74 / 104

OPERATION
SDX-102 05/19 Operation Section 4-32
© 2019 Alamo Group Inc.
OPERA
T
ION
After disconnecting the 3 lift points, remove the
implement driveline from the tractor PTO shaft. Lay
the driveline down carefully to avoid damaging the
driveline or its shield. Do not let the driveline fall into
mud or dirt, which can contaminate the bearing and
shorten the life of the driveline.
13. SNOW BLOWER STORAGE
Properly preparing and storing the snow blower at the end of the season is critical to maintaining its
appearance and to help ensure years of dependable service. The following are suggested storage procedures:
1. Thoroughly clean all debris off the implement to
prevent damage from standing water.
2. Lubricate all implements points and fill gearbox
oil levels as detailed in the maintenance
section.
3. Tighten all bolts and pins to the recommended
torque.
4. Check the implement for worn and damaged
parts. Perform repairs and make replacements
immediately so that the implement will be ready
for use at the start of the next season.
5. Store the implement in a clean, dry place with
the implement resting securely on blocks or at
ground level.
6. Keep the driveline’s yokes or hydraulic hoses from sitting in water, dirt and other contaminants.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
(SG-14)
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement. Place the Implement on the ground or securely
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
(S3PT-09)