Schulte 2 Series, Operator'S Manual

Page: 23 / 182

SAFETY
FX1800/FX1200 07/20 Safety Section 1-13
© 2020 Alamo Group Inc.
SA
FE
TY
TRANSPORTING HAZARDS
TO AVOID DEATH OR SERIOUS INJURY WHEN TOWING OR TRANSPORTING EQUIPMENT:
• KEEP transport speed BELOW 20 mph to maintain control of equipment.
• REDUCE SPEED on inclines, on turns and in poor towing conditions.
• DO NOT TOW with trucks or other vehicles.
• USE only properly sized and equipped tractor for towing equipment.
• FOLLOW all local traffic regulations.
TRACTOR REQUIREMENTS FOR TOWING OR TRANSPORTING IMPLEMENTS:
• ONLY TRANSPORT with tractor with ROPS in the raised position.
• USE properly sized and equipped tractor that exceeds implement weight by at least 20%.
• KEEP 20% of tractor weight on front wheels to maintain safe steering.
BEFORE TRANSPORTING OR TOWING IMPLEMENT:
TRACTOR INSPECTION:
• CHECK steering and braking for proper operation and in good condition.
• CHECK SMV sign, reflectors, stop lights, tail lights and hazard lights for proper operation and visibility behind unit.
• CHECK that your driving vision is not impaired by tractor, cab, or implement while seated in tractor seat.
• ADJUST your operating position, mirrors, and implement transport for clear vision for traveling and traffic conditions.
PREPARE IMPLEMENT FOR TRANSPORTING OR TOWING:
ENGAGE TRANSPORT LOCKS AND SAFETY CHAINS:
•
RAISE MOWER
and
ENGAGE
center axle cylinder transport stops or pins.
• RAISE WINGS and ENGAGE TRANSPORT LOCKS or pins.
•
ATTACH
implement
SAFETY CHAIN
to tractor.
• REMOVE any cut material collected on mower deck.
DETERMINE STOPPING CHARACTERISTICS OF TRACTOR AND IMPLEMENT FOR TRANSPORTING OR
TOWING:
BRAKING TESTS:
• INSTALL center axle cylinder transport stops or pins.
• Observe
STOPPING
distances increases with increased speeds.
• DETERMINE the maximum safe transport speed that does not exceed 20 mph.
DETERMINE MAXIMUM TURING SPEED BEFORE OPERATING ON ROADS OR UNEVEN GROUND:
• TEST equipment in slowly increasing speed in turns to determine it can be operated at higher speeds.
•
USE REDUCED
turning speeds in sharp turns to avoid equipment turning over.
WHEN TOWING OR TRANSPORTING EQUIPMENT:
• Always
WEAR SEAT BELT
when operating or transporting mower.
• USE low speeds to avoid overturn with raised wings.
•
USE
low speeds and gradual steering on curves, hills, rough or uneven surfaces and on wet roads.
• TURN ON tractor FLASHING WARNING LIGHTS .
•
ALLOW
clearance for implement swing while turning.
KEEP all raised wings at 10 feet or greater distance from all power lines and overhead obstructions.
PN TH01