17
3. Settings.
Settings and adjustments to the product or accessories may only be made by
people who have been given the necessary instructions by a medical product
advisor. Please ensure that none of the user‘s extremities are in the respective
area when making adjustments to avoid the risk of injury.
3.1 Presettings
The
momo tricycle.
is supplied completely as-
sembled. Prior to initial use, however, the follo-
wing pre-settings must be made.
3.1.1 Handlebar adjustment
You can find our scope of delivery for hand-
lebars on page 11 of these Instructions for use.
Height of handlebars
To adjust the height of the handlebars, remove
the protective cap from the hexagon socket
(
A
), loosen the hexagon socket (
A
) and adjust
the stem (
B
) to the required height. By tapping
the head of the hexagon socket (
E
) lightly with
a hammer, the stem in the fork steerer will loo-
sen. Then re-tighten the hexagon socket.
Ensure that the marking for the minimum in
-
sertion depth (C) remains on the stem in the
fork steerer and therefore cannot be seen.
Handlebar adjustment
To adjust the handlebar position, loosen the
clamping screws (
D
), bring the handlebars
into the required position and then firmly re-tighten the clamping screws.
To change the tilt angle on the stem, please loosen the clamping screw (
F
).
The steerer factory setting is 20°. In this way you can change the distance
between the saddle and the handlebars, and adjust the required handle
height. Then firmly retighten the screws again.
After each adjustment, please re-tighten all screw connections!
After adjustment of the handlebars, there must still be no tension
placed on the brake cables. If necessary, extend the cables!
F
D
A
D
B
E
C