Operation instructions
RAPID
®
Secure XL (screw-in tool)
www.schrauben.at
1
|
09/22
Technical data:
Power tool adapter
Hex type 11,5 (for 13 mm standard-chuck)
Max. lenght (incl. Bit) x diameter
207 mm x 46 mm
Weight
680 g
Bit adapter
Hex type 5/16”
Maximum torque
130 Nm
Drive shaft (1)
Holding element (4)
Bit (3)
Front clamping screw (5a)
Adjusting screw - inside (6)
Rear clamping screw (5b)
Protrusion length L
Power tool adapter (2)
Bit: T40 | 50 mm lenght - 5/16”
Bit: T 50 | 50 mm lenght - 5/16”
Suitable screws
Bit-protrusion length L
Suitable screws
Bit-protrusion length L
ø 8 mm Rapid
®
/
GPR
®
washer head
25.5 mm
ø 10 mm Rapid
®
/
GPR
®
countersunk head
28.0 mm
ø 8 mm Rapid
®
SuperSenkFix
25.5 mm
ø 12 mm Rapid
®
/
GPR
®
countersunk head
28.0 mm
ø 12 mm Rapid
®
Dual
25.5 mm
ø 10 mm Rapid
®
SuperSenkFix
28.0 mm
ø 12 mm Rapid
®
T-Lift
25.5 mm
Scope of application:
The RAPID
®
Secure XL screw in tool was designed for quick, safe and
effortless installation of long timber construction screws with a rotary
drill.
The RAPID
®
Secure XL screw-in tool allows safe overhead and angled
screwing. The screw’s head is reliably fixed in the screw-in tool and
results in longer life of the bits.
•
First familiarize yourself with the operating instructions for RAPID
®
Secure XL and the power tools you are using.
•
The user alone is liable for damage caused by improper use.
•
The generally accepted rules and regulations for the prevention of
accidents must be observed.
Bit setup:
•
At first loosen both clamping screws (5) slightly and remove the
inserted bit.
•
Clamp the power tool adapter (2) and loosen the axial adjusting
screw (6) using a 3 mm allen key (picture A).
•
Adjust the desired protrusion length L and fix the bit with the
clamping screws (5). Start tightening the front clamping screw (5a).
•
After fastening the first 100 operations, tighten the clamping screws
(5) again.
A
