•
Clean the condenser every 6 – 12 months with a vacuum cleaner or a brush to eliminate the dust
accumulation. This is located at rear of unit at the bottom and is the big wire part, you need to remove the rear
panel for access. An indoor unit will not need as much attention.
Storage inside the cabinet
-It is 100% not recommended to store blood or special pharmaceuticals in the fridge, warranty does not cover
‘contents’ in any circumstance
-Keep drinks at least 1cm away from walls to allow better air flow
Installation
•
Heavy: This appliance is heavy, take care when moving it. To avoid back or other injury, consider a two
person lift or mechanical aid when installing it. Failure to do so can result in back or other injury.
•
Built In & Freestanding design: This appliance is designed to be ‘built into’ cabinetry or freestanding, **Note:
Front venting bottom grill must be kept clear at all times, you cannot have cabinet doors in front of fridge doors, call
us for options if this is what you want to do.
•
Keep it upright: Do not tilt the fridge more than 45º from upright when moving it.
•
Handle with care: Do not apply force to any part such as the condenser or door, don’t carry holding door.
•
WARNING!
Ventilation: To ensure proper ventilation, keep any ventilation openings, in the appliance
enclosure or in the built-in structure, clear of obstructions. Ensure adequate air circulation around the appliance to
prevent overheating.
•
When positioning the appliance ensure the supply cord is not trapped or damaged.
•
Do not locate multiple portable socket outlets or portable power supplies at the rear of the appliance.
•
Level: Install the appliance level in order to ensure proper operation. If necessary, adjust the levelling legs at
the bottom of the unit.
•
Location: Install the appliance in an area that meets the following requirements:
- The ambient temperatures must correspond to the climate class (T) indicated on the rating plate of the appliance:
16°C to 43°C.
- The floor must be sturdy, level and strong enough to support the unit when fully loaded, avoid area’s where the
appliance would be exposed to direct sunlight, sources of heat, (stove, heater, radiator, etc.), extreme cold ambient
temperatures or excessive moisture and high humidity (such as outdoors or exposed to wind, rain water spray or
drips). Installing it in the coolest area of the room will the room will save energy consumption and running costs.
•
Avoid positioning anywhere where water can penetrate ‘under’ or on ‘top’ of the cooler. It could cause
damage to the internal workings and is potentially dangerous.
•
When In Position: Allow 30minutes and turn “ON”.
The importer is not responsible for damages or accidents arising from the misuse or disregard of electrical laws
relevant to the country where thus product is used
.
Summary of Contents for SK116
Page 7: ...Schmick ECO Controller ...