3
RSS36 AS
Operating instructions
Safety sensor
EN
AS-i parameter bits:
- P0:
Actuator present
- P1:
Hysteresis signal (FID)g
- P2:
Tamper protection time active (FID)
- P3:
Device error (FID)
Actuator detection (AD):
- P0 … P3:
Actuator number 0, 01 - 15
Parameter request:
default value parameter request "1111" (0xF)
AS-i Input module address:
0
- preset to address 0, can be changed through
AS-interface bus master or hand-held programming device
LED switching conditions display:
green/red LED (AS-i Duo LED):
Supply voltage /
communication error /
slave address = 0 /
periphery error detected /
Tamper protection time active
red LED:
Internal device error
yellow LED:
Device condition (enabling status) /
hysteresis signal
For use in NFPA 79 Applications only. Only for use in
Pollution Degree 2 Environment. Adapters providing field
wiring means are available from the manufacturer.
Refer to manufacturers information.
2.6 Safety classification
Standards:
ISO 13849-1, IEC 61508
PL:
e
Control Category:
4
PFH value:
≤ 5.13 x 10
-10
/ h
PFD:
≤ 3.24 x 10
-5
SIL:
suitable for SIL 3 applications
Service life:
20 years
3. Mounting
3.1 General mounting instructions
During fitting, the requirements of ISO 14119 must be
observed.
The universal mounting holes provide for a variable mounting by means
of M4 screws. The component can be mounted in any position. The
labelled surfaces of the safety sensor and the actuator have to be oppo-
site. The safety sensor must only be used within the assured switching
distances ≤ s
ao
and ≥ s
ar
.
The safety component and the actuator must be permanently
fitted to the safety guards and protected against displacement
by suitable measures (tamperproof screws, gluing, drilling,
pinning).
To avoid any interference inherent to this kind of system and any reduc-
tion of the switching distances, please observe the following guidelines:
• The presence of metal chips in the vicinity of the sensor is liable to
modify the switching distance.
• Keep away from metal chips.
• Minimum distance between two sensors: 100 mm
Accessories (to be ordered separately)
Sealing kit
• Ordering code 101215048
• 8 plugs and 4 washers
• to seal the mounting holes and as spacer
(approx. 3 mm) to facilitate the cleaning below the mounting surface
• also suitable as tampering protection for the screw fixings.
Kit tamper-proof screws
• 4 x M4x25 incl. washers, ordering code 101217746
• 4 x M4x30 incl. washers, ordering code 101217747
3.2 Dimensions
All measurements in mm.
Safety sensor RSS36-…-ST-AS
106
91
74
78
9
25
4,
5
18.5
6,
2
M1
2
2
22
High Level Code
Actuator RST36-1 / RST36-1-R
91
78
25
22
Alternative suitable actuators with different design: refer to
www.schmersal.net.
3.3 Switching distance
The side allows for a maximum height misalignment (X) of sensor and
actuator of ± 8 mm (e.g. mounting tolerance or due to guard door sag-
ging). The axial misalignment (y) is max. ± 18 mm.
Y
X
Latching versions X ± 5 mm, Y ± 3 mm.
The latching force will be reduced by misalignment.