OPERATION
30.30.01.00127/03
www.schmalz.com
EN | 34
Depositing loads
6.9
Lower the load and place it on a clear, flat surface so that it cannot slip or tilt.
V
ACU
M
ASTER
W
INDOW
Press the locking button and move the sleeve of the manual sliding valve on
the control handle into the “Vacuum off” position. The load is released.
V
ACU
M
ASTER
W
INDOW
C
OMFORT
Press the “Release” and “Suction ON” buttons on the operating panel to release the load. The
buttons must be pressed simultaneously.
In order to prevent the vacuum reservoir emptying, you should release the "Suction ON" button first
after lowering the item.
WARNING
Danger due to tilting parts
This can result in serious injury.
►
The workpiece must be securely on the floor or in a suitable storage device
before the load can be released from the gripper.
►
The load must be secured in such a way that it cannot slide or topple over after
the lifting device is released.
Parking the lifting device
6.10
Setting down the lifting device briefly in the off state is referred to as ‘parking’.
Procedure
:
1. Set down the pump.
2. Hang the lifting device in a safe position on the crane system or position in a holding device (do
not set down on the workpiece!).
