7.2 Mounting
The ejector may be installed in any position.
There are two 4.4 mm mounting holes for mounting the ejector.
A DIN rail mount for DIN rail TS35 can be used as a mounting option.
1
2
1
DIN rail mount for TS35 DIN rail, incl. plastic
tapping screws
Max. tightening torque 0.5 Nm
2
2x M4 fastening screws with washers
When mounting with fastening screws, use M4 washers (2 Nm max. tightening torque).
For the start of operations, the ejector must be connected to the control via the connection plug with a connection
cable. The compressed air required to generate the vacuum is connected via the compressed air connection. The
compressed air supply must be supplied by the higher-level machine.
The vacuum circuit is connected to the vacuum connection.
The installation process is described and explained in detail below.
7.3 Pneumatic Connection
CAUTION
Compressed air or vacuum in direct contact with the eye
Severe eye injury
4
Wear eye protection
4
Do not look into compressed air openings
4
Do not look into the silencer air stream
4
Do not look into vacuum openings, e.g. suction cups
CAUTION
Noise pollution due to incorrect installation of the pressure and vacuum connections
Hearing damage
4
Correct installation.
4
Wear ear protectors.
12 / 20
EN-US · 30.30.01.02662 · 00 · 02/21
