Schmalz SCPi, Brief Operating Instructions, Page: 21 / 68

S
CHMALZ
SCP
I
/ SMP
I
GB - 7
Manual mode
The output signals may change during set-up in manual mode.
Ensure that the machine or system does not start moving as a result.
Personal injury or damage to the ejector could occur as a result.
Manual mode can be used for locating and eliminating leakage.The ejector can be con-
trolled manually using the buttons on the membrane keypad. In this operating mode, the
H1 and H2 LEDs both flash.
A
CTIVATING MANUAL MODE
Activate manual mode as follows:

Press and hold the and buttons together for more than 3 seconds.

Manual mode can be used even if actuator voltage is not present (emergency
stop, setup mode).
M
ANUAL SUCTION
The suction mode is activated in manual mode by pressing the button. The suction
mode is exited by pressing the button again or by pressing the button.

This is also active in manual mode when the air-saving function is activated
[ctr=on]
(RD ejectors). This applies even if actuator voltage is not present.
Instead off the Error code
[E05]
the actual vaccum value is shown.

The valve protection function is not active in manual mode.
M
ANUAL BLOW
-
OFF
The blow-off mode is activated in manual mode by pressing the button. The mode
remains active as long as the button is pressed.

If actuator voltage is not present, manual blow-off mode is not available. Error
code
[E05]
is displayed.