Installation
EN-US · 30.30.01.02553 · 00 · 09/20
33 / 52
1. Open the receiver cover using a Phillips head
screwdriver PH2.
2. Ensure that the circuit board is supplied with a
voltage. The LED (6.7) is illuminated.
3. Press the
CLEAR
button (6.8) for one second.
ð
LED6 (6.10) lights up for 3 seconds.
ð
LED6 (6.10) begins to flash at regular inter-
vals.
4. Actuate the transmitter to be registered on
the operator handle (6.1 button).
6.1
5. Press the
LEARN
button (6.9) for one second
to end the registration process.
ð
If no button is pressed, the registration
process is ended after approx. 10 seconds.
ð
The transmitter is saved.
4
Close the receiver cover (6.4) and tighten all screws.
6.10.3 Registering an Additional Transmitter
1. While registering an additional transmitter, ensure that a previously registered SRC trans-
mitter is not operated.
2. The registration of each transmitter must be completed before the next transmitter can
be registered.
1. Press the
LEARN
button for one second to start the registration process.
ð
LED6 (6.10) begins to flash at regular intervals.
2. Actuate the transmitter to be registered on the operator handle (6.1 button).
ð
LED6 (6.10) lights up for 3 seconds.
ð
LED6 (6.10) begins to flash at regular intervals.
3. Press the
LEARN
button (6.9) for one second to end the registration process.
ð
If no button is pressed, the registration process is ended after approx. 10 seconds.
ð
The transmitter is saved.
4
Close the receiver cover (6.4) and tighten all screws.
6.11 Installing the Silencer Box (Option)
See the silencer box operating instructions in the appendix.
