Description of Functions
28 / 52
EN-US · 30.30.01.01963 · 00 · 05/19
Unit
Explanation
The setting for this unit is [
iX9
].
psi
The vacuum level is displayed in psi.
The setting for this unit is [
P5i
].
6.8 Reset to factory settings
This function is used to reset the following configurations to their factory settings:
•
the configuration of the ejector
•
the initial setup
This function is executed using the parameter [
rE5
] in the EF menu.
The factory settings for the ejector are listed in the Technical Data section.
WARNING
By activating/deactivating the product, output signals lead to an action in the pro-
duction process!
Personal injury
4
Avoid possible danger zone.
4
Remain vigilant.
A description of how to reset the ejector to factory settings using the display and operating element fol-
lows:
ü
The EF menu is open.
1. Use the
button to select the parameter [
rE5
].
2. Confirm using the
button.
3. Use the
button to select [
YE5
] for the parameter value.
4. Confirm using the
button.
ð
The ejector is reset to the factory settings.
The reset to factory settings function does not affect the following elements:
•
The counter readings
•
The zero-point adjustment of the sensor
6.9 Counters
The ejector has two internal counters, [
cc1
] and [
cc2
], which cannot be erased:
Counter 1 increases with each valid pulse at the “suction” signal input, meaning that it counts all the suc-
tion cycles during the ejector’s service life.
Counter 2 increases each time the “suction” valve is switched on. As a result, the average switching fre-
quency of the air saving function can be determined using the difference between counters 1 and 2.
