Schluter Systems LIPROTEC LT ES 1, Directions For Use Manual

Page: 38 / 219

EN
Disposal
Directions for use for LED strips 35

Disconnect the power pack from the mains connection. For this purpose, loosen the
screws (see
directions for using the power pack
, fig. D item 3) and remove the housing
covers (see
directions for using the power pack
, fig. D item 2).

Disconnect the mains cable from the power pack and strip the exposed wires.

You can now disassemble the individual components of the LIPROTEC system.
12.2 Disassembly of the LED strip
To disassemble the LED strip, proceed as follows:

Open the respective installation box.

Loosen the connection cable from the terminal connectors.

If you use empty tubes and want to install a new LED strip, connect a pull cord to the
loose end of the connection cable.

With this pull cord, you can later pull the connection cable of the new LED strip into
the cable channel or empty tube.

Pull the connection cable from the empty tube.

If necessary, make sure the pull cord remains accessible on the other end.

Loosen the LED strip from the foundation by pulling it off and upward vertically.
13 Disposal
This product must not be disposed of in domestic waste within the EU. The
recyclable materials contained in old components must be recycled. The
environment and/or human health must not be damaged by unmonitored waste
disposal. Please dispose of old components through suitable collection systems or
send the component to the place where you purchased it for disposal. The
component is then sent to material recycling.
14 Warranty conditions
The current warranty conditions of Schlüter-Systems KG for the Schlüter
®
LIPROTEC
system can be found on the Internet under the address "www.liprotec.de."