Schluter Systems LIPROTEC LT ES 1, Directions For Use Manual

Page: 35 / 219

EN
Commissioning
32 Directions for use for LED strips

Conduct the cable to the power pack.

Lay the cable to the 24V terminals of the power pack. In the process, guarantee the
correct polarity. For this purpose, read the directions for use of the power pack as well.
Connecting several LED strips directly to a power pack

Pull the connection cable of the LED strips into cable channels or empty tubes as
described above.

Conduct the connection cables into an installation box.

Combine the wires of the connections of the LED strips to one LIPROTEC-ZKL terminal
connector having the same colour each. For each wire, use a single contact of the
terminal connector (see Fig. J).

Depending on the type of the terminal connector, you can connect two or four LED
strips.

Connect the terminal connectors to the power pack with an additional cable. For this
purpose, use a LIPROTEC LT ZK 2A cable. Make sure the correct polarity is observed
and the maximum permissible length of 10 m is not exceeded. For this purpose, read
the directions for use of the power pack as well.
6.4 Connecting the LED strip to the receiver
Connecting one or more LED strips to a receiver

Conduct the connection cable of the LED strip to the incoming cable channel through
the borehole of the mounting profile.

Establish a cable reserve by looping the cable at the beginning of the channel. During
the course of mounting, make sure this cable loop is not impaired.

This guarantees that the LED strips can be removed from the profile without the
cable becoming tensioned.

Conduct the connection cables of the LED strip and receiver into an installation box.

Combine the wires of the connections of the LED strips and the receivers to one
LIPROTEC-ZKL terminal connector having the same colour each. For each wire, use a
single contact of the terminal connector (see Fig. H, I and J).

Depending on the type of the terminal connector, you can connect two or four LED
strips.
6.5 Connecting the LED strip to a building automation system
A building automation system with a 24V connection can be used instead of a LIRPROTEC
power pack (see Fig. G).

Details regarding the connection to the building automation system can be found in the
respective documentation of the external components.