Schluter Systems LIPROTEC LT ES 1, Directions For Use Manual

Page: 37 / 219

EN
Repair
34 Directions for use for LED strips
Fault Cause of fault Troubleshooting
connections)
Lighting flashes
or flickers
Receiver overloaded Check the maximum load of the respective
connections on the receiver. The LED strips
might have to be distributed over the
respective connections (observe the
maximum load of the respective
connections)
Power pack overloaded Select a larger power pack (up to 150 W)
Cable connections are
not firmly tightened
Check the cable connections for non-
positive locking.
Different light
colours
Connections mixed up Check all cable connections for a proper
connection Test the colours red, green and
blue. Test the colour temperature warm
white or daylight white.
Line protection
breaker triggers
Power pack incorrectly
connected
Connect the power pack correctly (only by
an electrician).
11 Repair
Due to the design, the repair of a LIPROTEC component is not possible.

If a component has a defect or power loss, you can exchange it for a new one.

In the process, follow the instructions in the "Decommissioning," "Mounting," and
"Commissioning" sections.
12 Decommissioning, disassembly
DANGER
Electrical shock is possible in case of improper disassembly.
Disassembly by unauthorised personnel can lead to a deadly electrical shock.

Have the component decommissioned and disassembled by qualified, expert
personnel only.
12.1 Decommissioning
To decommission the LIPROTEC system, proceed as follows:

Switch off the LIPROTEC system.

Switch off the mains connection of the power pack and secure it against reactivation.