Schluter Systems LIPROTEC LT ES 1, Directions For Use Manual

Page: 28 / 219

EN
Description
Directions for use for LED strips 25
2.8 Warning and information signs
Symbol Explanation
Corresponds with the requirements of Directives 2004/108/EC and
2006/95/EC.
Suitable for direct assembly to normally flammable surfaces. Normal
flammable surfaces are materials such as wood and materials on a wooden
basis with a thickness of no more than 2 mm.
Suitable for mount onto or into furniture, consisting of materials with unknown
ignition properties.
Corresponds with protection class III (uses safety extra low voltage)
Corresponds with EU Directive 2011/65/EU to limit the use of certain
hazardous materials in electrical and electronic devices.
Corresponds with protection class IP65 (IEC 60529:1989 + A1 :1999 +
A2:2013):
Protection against spray water (nozzle) from any angle.
Corresponds with protection class IP67 (IEC 60529:1989 + A1 :1999 +
A2:2013):
Protection against occasional submersion
Subject to the Waste Electrical and Electronic Equipment (WEEE) Directive
2012/19/EU governing waste electrical and electronic equipment. See
Chapter 13 "Disposal."
3 Description
3.1 Scope of supply
A diagram of the scope of delivery can be found as Figure A on the fold-out pages at the
beginning of the document.
The scope of supply of an LED strip consists of:

LED strip on roll (1)

End caps (3)

Sealing glue (4)
 Directions for use
3.2 Task and function
The Schlüter® LIPROTEC light profile technology is an LED system that enables a variety of
mainly indirect light effects. The system, which is installed into walls and ceilings, is used to
create decorative or accentuating indoor lighting effects.