9. Servicing / Maintenance
236 | 268
Original Operating Manual | Edition 1.0 (01-2020) | CrimpCenter 64 SP
9.10
MAINTENANCE SHEET - EXCHANGING BLADE
Cutter Block - Change Blades
Task
Remove cutter blocks, change blades, mount cutter blocks
Unit
Cutter blocks
Duration
approx. 20 min.
Interval
Individual
Personnel qualifica-
tion
Qualified Personnel
Parts
Allen wrench 4 mm
WARNING
Personnel Qualification and Personal Protective Equipment!
The following instructions are to be followed!
Maintenance work may only be executed by technical specialist.
See also chapter “Personnel Qualification” and “Personal Protective
Equipment”.
DANGER
Risk of injury if not observed!
You may suffer serious injuries, if the machine is switched on acciden-
tally!
The following instructions are to be followed!
Prior to operating the following points have to be observed:
Put the main switch in position "OFF"!
Protect the machine against reactivation.
Take appropriate measures to ensure, that only you can reactivate
the machine.
Affix a warning sign: "Do not switch on the Machine!"
DANGER
Risk of injury if the protective equipment is inadequate!
You may injure seriously when the protective equipment is insufficient.
The blades are very sharp and are not protected! There is a risk of being
cut!
The following instructions are to be followed!
For works on the blades and the cutter blocks wear cut resistant
gloves, when the safety cover is open!