8. Commissioning
Original Operating Manual | Edition 1.0 (01-2020) | CrimpCenter 64 SP
165 | 268
8.7.13
Adjust the Clamping Force of the Gripper
Fig. 79: Gripper - Contact pressure
The pressure regulator is located under the
wire feeding unit.
Here the contact pressure can be read.
The pressure should be adjusted so that
no print marks are displayed on the wire.
the gripper keeps the wire safe during
the stripping process without it slipping.
You can set the desired pressure in the EASY software.
The following steps will show you how to do this.
1.
▹
Switch to the tab Swivel.
(The following pages will tell you how to get there.)
2.
▹
Enter the desired pressure there.
3.
▹
Apply the value.
The set pressure is saved with the order data.
The pressure is automatically adjusted on load of the order.
The pressure of the active order will be applied.
EASY - Settings
Tab - Swivel
Press the following button:
Press the following button:
In this tab you can make the following settings.
Picture / Screen text
Translation
Description
Pull-off speed
Pull-off speed
Here you can set the pull-off speed of the
swivel.
Swivel movement
speed side 1
Swivel movement
speed side 1
Here you can set the speed, at which the
swivel moves away on side 1.
Swivel movement
speed side 2
Swivel movement
speed side 2
Here you can set the speed, at which the
swivel moves away on side 2.