8. Commissioning
120 | 268
Original Operating Manual | Edition 1.0 (01-2020) | CrimpCenter 64 SP
COMMISSIONING
Prior to initial operation the machine has to be in its final position. All transport locks must
have been removed and all work in chapters
"7 Installation / Mounting (Page 97)"
must have
been completed.
WARNING
Danger of injury during commissioning, adjustment and set-up
work!
The following instructions are to be followed!
DANGER
Risk of injury if not observed!
The following instructions are to be followed!
Prior to operating the following points have to be observed:
Make sure that all live components are covered appropriately.
When switching on the machine, all safety devices have to be
installed and functioning.
Make sure that no individuals are in the danger zones.
Observe the danger zones.
Make a visual inspection of all cables and pneumatic hoses. Defec-
tive cables and hoses are to be replaced by a specialist.
The stations of the CrimpCenter have their own operating manual
with safety advices, which have to be followed.
Processing stations must be tightly mounted on the support desig-
nated by
Schleuniger
when starting production.
Superiors must ensure that personnel have understood the opera-
tion and safety regulations.
DANGER
Risk of injury when the confirmation button is pressed!
Pressing the confirm button when the safety cover is open deactivates
some safety functions.
The following instructions are to be followed!
The person, which is actuating the confirm button, is responsible
that no other person is in the danger zones!
Only trained personnel are allowed to use the confirm button.