Schleuniger CoaxCenter 6000, Reference Manual, Page: 109 / 194

10. User interface / user levels
Reference Manual |Edition 5.0 (09-2016) | CoaxCenter 6000
109 | 194
10.3
USER LEVEL CONTROL
1
1
2
3
1
Maintenance
2
Programmer
3
Operator
The settings in the "User levels" screen apply to the user level control of the CoaxCenter 6000 software.
It is possible to work in three different user levels.
The user logged in to a user level has only access to the commands and parameters designated for
this level. To e. g. change a configuration setting, the user must be logged in to the „Mainte-
nance“ level.
Password
User level setting:
Selection of the user level in which the user has to be logged-in after restarting
the control software. The password can be changed individually on each user level. Initial factory
default passwords are programmed.
Touch
Change password:
The password can be changed individually for each user level. The new
password can be entered via the alphanumeric touch-keyboard (max. 14 characters). The password is
displayed encrypted.
Password reset:
The factory default initial passwords remain in the memory even if they have been
renamed. While resetting the passwords to its initial settings all levels are affected. To carry out this,
the user must be logged in to the user level "Maintenance".
After a new
CoaxCenter 6000 has left the factory, the following passwords are predefined (factory set-
up):
User level Password
Operator 1
Programmer 12
Maintenance 123
Tab. 4: Preset passwords (factory default)
If the password for the user level "Maintenance" becomes lost, please contact your local
Schleuniger
distributor.