Schiller Grounds Care Bunton 632006, Parts Manual

Page: 8 / 46

6
Bunton
Bullet
ASSEMBLY/SET-UP INSTRUCTIONS
11. Fill engine with oil. (See engine manual for specifications.)
12. Fill fuel tank with with clean, fresh unleaded fuel.
GASOLINE IS HIGHLY FLAMMABLE!
•
Fill fuel tank with good quality, clean, regular unleaded gasoline.
•
Do not use hi-test fuel.
•
Do not smoke.
•
Do not spill fuel.
•
Fill outdoors.
•
Do not overfill. Fill to 1" below bottom of filler neck to allow room for expansion.
•
USE A FUNNEL TO FILL GAS TANK.
13. Adjust tire pressure in drive wheels and casters to 14 psi (96 kPa).
14. Before attempting to start the mower, read and understand all sections of the Operation & Safety manual.
NOTICE : Special setup instructions.
•
Before engaging the cutterdeck, run the engine for five minutes at full RPM. This is recommended for
new engine installation to permit complete engine lubrication prior to load.
•
Do not engage the cutterdeck at full throttle. Set the throttle half way between the highest and lowest
engine speed, engage the PTO switch and increase the engine speed to full before cutting.
•
Do not use this machine without an approved grasscatcher, grass discharge chute or mulching plate(s)
correctly fitted.