Schiller Grounds Care BOB-CAT 942221F, Operator'S Manual

Page: 36 / 42

34
ZT 200
Series
ADJUSTMENTS
DECk LEVELING
1. Park the machine on a smooth, level surface.
Raise the deck to the transport position.
2. Lower the deck onto a set of equal height blocks
A under the rear corners of the deck. Place an-
other set of blocks B under the front of the deck
so that the deck top is pitched forward 1/8".
NOTE: The front and rear of the deck are at different
heights.
3. Measure the height of the blade cutting edge
above the ground. Remove pin C and set the
height of cut lever D to that height.
4. Loosen nuts I at all four corners of the deck.
NOTE:
This will relieve tension on chains
H
.
5. Loosen the jam nuts E on the height of cut
clips F and adjusting screws G . Turn the adjust-
ing screws G until the play is taken out of the
chains H at all four corners. Tighten the jam nuts
E against the clips F and at the adjusting screws
G . Retighten nuts I at this time.
COUNTERBALANCE SPRINGS
1. Raise the cutterdeck all the way.
2. Adjust the spring
A with nut B :
52" cutterdecks to a length of 9-1/8" (232 mm)
61" cutterdecks to a length of 9-9/16" (242 mm)
The springs may be tightened or loosened from
this point according to personal preference.
NOTE: The 48" cutterdecks do not have
counterbalance springs.