19
ZT 200
Series
CONTROLS
PARkING BRAkE (R)
- Pull the parking brake
lever up and back to put the parking brake ON. Push
it forward and down to put the parking brake OFF.
The parking brake must be ON to start the engine.
It must also be ON to keep the engine running if the
operator leaves the seat. The parking brake must be
OFF to keep the engine running when a traction lever
is moved out of neutral lock.
PUSHING THE MACHINE
Hydrostat bypass valves (“dump valves”) on each
hydrostatic pump allow the machine to be pushed or
towed without the engine running. Raise the seat to
gain access to these two valves
U
. Turn both valves
counterclockwise 1 turn to release the hydrostatic
system. Restore the hydrostatic system by turning
the valves clockwise only until they re-seat.
DO NOT
overtighten.
Use caution if it is necessary to tow the machine.
With the bypass valves open, the dynamic braking
and steering provided by the hydrostats is disabled.
Towing should be done only if a disabled machine
cannot be repaired where it broke down.
Compartment beneath the seat,
viewed from above
Parking brake in ON position
(operator's left side)
Summary of Contents for BOB-CAT 942221F
