!
9
CARE
boy
Troubleshooting
CARE
boy
Problem
Causes
Solution
LED indication works well, no reaction when
pressing Start / Stop button, spray button,
machine doesn‘t work
AAA-Batteries run out
Replace the batteries in the battery
compartment on the handle
Failure when spraying
Lack of liquid
Fill the tank as described
Air has got into the pipe
Press the spray button a few times to
allow air to escape
Nozzle is blocked
Something blocks the nozzle, there
are hard components contained in
the liquid
Clean nozzle with a needle
Nozzle leaks
There are some hard
components contained in the liquid
Rinse the nozzle with clean water
One green light on detachable battery works well
Low battery
Recharge battery
LED works well, spraying works well,
motors don‘t work
Overheating protection
Turn off the
CARE
boy and continue
your work after the machine has
cooled down
LED is off, failure when spraying,
motors don‘t work, Lights on the battery
flickerwhen the adapter is plugged in
Overcurrent protection
Plug in the device for a few seconds to
reactivate it
Low power
Charge the machine for several se-
conds unplug it, Recharge asap
TROUBLE
SHOOTING.
During prolonged operations, the engine temperature rises . In this case, the overheating protection stops the engine .
Turn off your
CARE
boy and allow it to cool down without an external support .
Do not work longer than 20 minutes without interruption .
Do not put extra weight on the
CARE
boy .
If troubles can not be solved accoring to this manual, please contact your dealer or
Scheucher Holzindustrie GmbH at www .scheucherparkett .at!
Please note: