Error messages and malfunctions
6 ERROR
MESSAGES
AND
MALFUNCTIONS
6.1 Display
messages
Display
Cause Rectification
cleaning program
12:00 01.05.2003
(sTxt-021, Fix)
-
This message appears during the quick
flush, initiated by pressing and holding the
cleaning button for 5 seconds.
cleaning program
insert tablet
(sTxt-024)
-
In the cleaning program, after you use the
brush, and slide the grounds container
back in place, the machine will prompt you
that you may now insert the Schaerer
cleaning tablet in the tablet opening.
cleaning program
remove container
(sTxt-021,sTxt,-022)
-
When you first press the cleaning program
button to initiate the cleaning cycle, the
display prompts you to remove the grounds
bin. You need to do this immediately.
cleaning program
selection locked
(sTxt-021,sTxt,-002)
-
This message appears while the cleaning
program is running. During the cleaning
cycle all product buttons are locked out.
The machine can be used again when “se-
lect beverage” appears on display.
-
If the message persists for more than 5
minutes, call for service.
<< flush >>
heating
(sTxt-005,sTxt,-172)
-
After the cleaning program is finished and
the machine is turned off (overnight) and
turned on again (next day), it will start a
water flush, after it has heated up.
-
If message persists, call for service.
<< flush >>
selection locked
(sTxt-005,sTxt,-002)
-
Message indicates that the machine is in
the middle of a flush. Message will disap-
pear when flush is finished.
-
If message persists, call for service.
select beverage
12:00 01.05.2003
(sTxt-003, Fix)
-
The machine is ready for dispensing. The
product buttons are ready for use (select).
The lower left corner indicates the time
(military) and the lower right hand corner
indicates the date (day.month.year).
select beverage
clean machine
(sTxt-003,sTxt,-171)
-
The display prompts this message when
the machine has been dispensing a preset
(programmable) number of beverages
without a cleaning.
-
The only way to clear this message from
the display is by initiating the cleaning pro-
gram.
select beverage
grinder left empty
(sTxt-003,sTxt,-178)
1) This usually indicates that the left hopper
is empty.
2) It may also mean that the bean flow into
the grinder is blocked (i.e. sticky beans,
piece of plastic).
Left espresso outlets are disabled
1) If so, fill hopper with beans
(
max. 1.8 lbs /
0.75 kg per container
)
and hit the ‘reset’
button to continue the grind cycle.
2) So, if the hopper is full, stir the beans with
the back of the cleaning brush, then hit the
reset button, if necessary two or three times.
-
If message persists, call for service.
Page 6-2
BASO-1 SUSA - 02.06 - V01 - V02
