Scarab M65T, Operating And Basic Maintenance Instructions

Page: 25 / 58

Scarab M65T Operating Instructions
Part No. SCAZ043468 1.6.01 25 E&OE
Auxiliary Hand Pump
The auxiliary hand pump is used to raise the hopper or open the rear door if the auxiliary engine has failed, hydraulic pump is not working or there is electrical
failure on the machine.
Proceed as follows if there is electrical power available on the machine:
1. Vehicle engine off. Parking brake engaged.
2. Switch the ignition on. Do not start the vehicle engine.
3. Insert the pump handle.
4. Press and hold the safety interlock button and either the hopper raise or door open button.
5. While the above buttons are being held operate the hand pump handle ( 5 ) . See illustration to the
right.
If electrical power is unavailable on the machine then proceed as follows:-
1. To raise the hopper depress the locking button ( 1 ) and pull out the control ring ( 2 ) .
To lower the hopper, ensure that the hopper safety prop is not in the deployed position, then depress
the locking button ( 1 ) and push in the control ring ( 2 ) .
See illustration to the right.
2. To open the rear door depress the locking button ( 3 ) and pull out the control ring ( 4 ) .
To close the rear door, ensure that the rear door safety prop has been removed and stowed, then
depress the locking button ( 3 ) and push in the control ring ( 4 ) .
See illustration to the right.
3. Operate the hand pump handle ( 5 ) .
The hopper safety prop should always be in the deployed position when the hopper is in the raised
position. Failure to do so could result in serious injury. See page 13.
Rear door safety prop should also be deployed if working beneath it and the rear door is open.
3
4
5
1
2
Hopper raise and
lower valve
Rear door open
and close valve