COMPACT 75
COMPACT 75
Operator’s manual for drilling machine
- 7 -
It is recommended to use the safety chain following the pictures
6. Do not use the machine in explosion hazard zones.
7. Do not start to work if the machine has excessive play on guide slides.
8. Always wear safety goggles and ear protection.
9. Do not remove metal chips with bare hands.
10. Do not touch the spindle and the cutter during work.
Do not touch or replace the tool with power source on – while
electromagnetic base is being used.
11. Tools must be fastened firmly. When a milling cutter is used, check before start of work if tool
holding screws are screwed tight.
12. It is not permitted to use blunt of damaged tools.
13. Do not use milling cutter without pilots, and arbors without ejection spring.
14. Use only tools recommended in Operator’s Manual.
15. After use always clean drilling machine from metal chips and coolant.
16. Always unplug machine from power supply during any work on the machine.
17. Before each use the machine should be checked for the presence of damage and the proper
and consistent use. Check whether any of the parts are broken and all the parts are fasten
properly. Make sure to maintain proper conditions affecting work of the machine.
18. In the case that the machine falls on a hard surface, from a height, is wet or is subjected to
other unfortunate events that could affect its technical state – work should be terminated
immediately and the machine should be sent to service for inspection as soon as possible.
Drawing No 1 The safety chain application
