Scanivalve MPS4232, Hardware And Software Manual

Page: 58 / 96

52
MPS4232
Section 5: Software
Identification Variables
The identification settings control the serial number and the nominal pressure range of the MPS4200.
List Identification Settings (LIST ID)
DESCRIPTION Returns all of the identification settings.
SYNTAX LIST ID
RETURNS All settings followed by the prompt.
EXAMPLE
LIST ID
SET SN 222
SET NPR 5.0000 -5.0000 5.0000 -5.0000
SET MCAST 224.0.1.2
>
Set Serial Number (SN)
COMMAND SN
TYPE Set/Get
DESCRIPTION Sets the serial number of the MPS.
SYNTAX SET SN <sn>
Where:
<sn> is the serial number ranging from 0 to 32767.
RETURNS Prompt when ready to accept a new command
EXAMPLE
SET SN 123
>
DEFAULT 100
RANGE 0 to 32767
NOTES This value will get printed to the name of the Cal.cfg file when a SAVE C is issued. Format is:
Cal_<sn>.cfg
Set Nominal Pressure Range (NPR)
COMMAND NPR
TYPE Set/Get
DESCRIPTION Sets the nominal pressure ranges for the MPS
SYNTAX SET NPR <npr1p> <npr1n>
Where:
<npr1p> is the maximum nominal pressure for channels 1 to 32.
<npr1n> is the minimum nominal pressure for channels 1 to 32.
RETURNS Prompt when ready to accept a new command
EXAMPLE SET NPR 15.0 -15.0
>
DEFAULT 15.0 -15.0
Set the Multiple Device Multicast Address (MCAST)
COMMAND MCAST
TYPE Set/Get
DESCRIPTION Sets the multicast IP address used for multiple unit calibration and validation. This address must
be the same for all units to be calibrated as a group.