STARTER BED ASSEMBLY INSTRUCTIONS
1 - Ends Assembly
Ends Assembly Components:
Box 1 & Box 3
Fittings Pack (End Assembly)
(A) 8mm Dowel Qty = 12
(B) Cam Pin Qty = 8
(C) Cam (Already In Panel) Qty = 8
A
A
A
B
B
Cam C
Dowel Holes
B
A
A
PANEL
1) Place legs on a flat surface taking care not to scratch. Insert 8mm dowels (
A
) into holes with light
hammer.
Screw cam pins (
B
) carefully into 5mm holes, to top of the thread, using cross slot screwdriver.
Repeat process for the other three legs.
2) Ensure cams (
C
) are inserted in the panel with the arrow pointing to the edge. Carefully locate the
panel onto the dowels and cam pins. When in place, turn the cam clockwise with cross-slot screwdriver to
lock.
Ensure the legs are attached to the panel in pairs ie: dowel holes are facing the same way.
Please read & check through these instructions carefully before proceeding with assembly
COMPONENTS
Box 1 of 4 End Panels
2 x End Panels with 8 Cams Inserted
Box 2 of 4 Bed Rails
2 x Side Rails (with Rib)
2 x Long Safety Rails
2 x Short Safety Rails
1 x Support Leg
1 x Fittings Pack (Bed Assembly)
Box 3 of 4 Bed Legs
2 x Right Handed Legs
2 x Left Handed Legs
1 x Fittings Pack (End Assembly)
Box 4 of 4 Bed Slats
1x Set of Slats
Tools Required (Not Supplied)
2)
1)
