Scale Installation
7600413 REVA
Page 4
SCALE BRACKET AND LOAD CELL MOUNTING INSTALLATION
Scale Installation
The scale kit consists of mounting two spindle load cells, one hitch load cell, one J-box and a scale
indicator to support the grain cart.
1. Jack up one side of the cart utilizing a jack or lifting device that will support the full weight of the
grain cart.
SAFETY!!!
Ensure you properly block the Grain Cart to provide support in the event of a jack
failure or lifting device failure. Only install one side at a time. Lifting both sides simultaneously may be
too unstable and result in serious injury or death.
2. Remove the Wheel and Hub Assembly
Fig. 1
Refer to Fig. 1
To remove the hub….
i.
Remove the Hub Cap.
ii.
Remove the Hub Gasket (if
installed).
iii.
Remove the Cotter Key / Role
Pin.
iv.
Remove the Castle Nut.
v.
Remove the Outer Washer.
vi.
Remove the Hub.
vii.
Remove the Inner Washer.
viii.
Remove the Hub seal.
Refer to Fig. 2
i.
Remove the spindle retaining bolt
and slide the spindle out.
IMPORTANT! It may be necessary
to utilize a large pipe wrench, penetrating
oil, or a slam hammer to remove rusted in
axles. As a last resort, heat the sleeves
with a torch to remove spindles.
Fig. 2
Fig. 2
