INTRODUCTION
7600413 REVA
Page 3
INTRODUCTION
Congratulations on the purchase of your new Scale-Tec Grain Cart scale system. This scale system is
specifically designed to weigh the hopper on your Grain Cart. This scale kit is specifically designed for
your make and model of Grain Cart. These instructions will guide you through general installation of the
kit. The scale kit can be used to record and monitor seed weight going into or out of the grain cart.
This
SAFETY ALERT SYMBOL
indicates important safety messages in the manual. When you see
this symbol, be alert to the possibility of PERSONAL INJURY and carefully read the message that follows.
NEVER OPERATE WITHOUT ALL COVERS, SHIELDS AND GUARDS IN PLACE.
KEEPHANDS, FEET AND CLOTHING AWAY FROM MOVING PARTS. FAILURE TO HEED MAY RESULT
INSERIOUS PERSONAL INJURY OR DEATH.
Some covers and guards have been removed for illustrative/photographic purposes only in this manual.
For information on ordering repair parts, refer to Parts Section in this book.
This supersedes all previous published instructions.
IMPORTANT!
Charging Battery and Welding
Disconnect all cables from the weighing indicator before charging the battery or welding on the
machine. If cables are left connected, the weighing indicator and connected load cells could be
damaged.
Important:
Do not weld near indicator, load cells or cables; remove from area to be welded. Place
ground close to area to be welded to prevent current from passing through electronic parts.
