Scag Power Equipment SPZ52-22FX, Operator'S Manual

Page: 34 / 73

30
R
Section 7
7.1 MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS
HOURS
PROCEDURE COMMENTS
BREAK-IN
(FIRST 10)
8 20 40 100 200 400 500
X
Check all hardware for tightness
X
Check hydraulic oil level See paragraph 7.2
X
Check all belts for proper alignment See paragraph 7.7
X
Check engine oil level See paragraph 7.3
X
Check hydraulic hoses for leaks Use extreme caution when
checking the hydraulic hoses. See
paragraph 2.6
X
*Clean mower See paragraph 7.10
X
Check condition of blades See paragraph 7.8
X
Check tire pressure See paragraph 7.9
X
Inspect seat belt for wear or damage See paragraph 2.6
X
Check safety interlock system See paragraph 4.3
X
Change engine oil and filter See paragraph 7.3
X
Grease front caster wheel bearings
X
Check battery, clean battery posts and
cables See paragraph 7.6
X
Inspect pump drive belt. Replace every
400 hours or 2 years, whichever occurs
first. See paragraph 6.4 & 7.7
X
Check belts for proper alignment See paragraph 7.7
X
Check condition of fuel lines
X
Change engine oil See paragraph 7.3
X
Drain hydraulic system, replace hydraulic
oil and filters Use SAE 20W50 Motor Oil.
See paragraph 7.2
X
*Clean air cleaner element See paragraph 7.5
X Check all hardware for tightness
X Change engine oil and filter See paragraph 7.3
X Check hydraulic oil level See paragraph 7.2
X Replace engine fuel filter See paragraph 7.4
X Adjust electric PTO clutch See paragraph 6.7
X Drain hydraulic system, replace hydraulic
oil and filters Use SAE 20W50 Motor Oil.
See paragraph 7.2
MAINTENANCE
* Perform these maintenance procedures more frequently under extreme dusty or dirty conditions