OPT
AUX 1
OPT
USB
AUX 2
VOL+
VOL-
12
EN
The POWER button on the remote control is used to switch from operation mode
to standby and back. The operating status can be recognized using the right LED
on the front: If this is glowing brightly: ON. If dark: OFF.
An already established Bluetooth connection to an audio source is retained in
standby mode.
Connection
Make sure that the POWER switch is in the OFF position. The power should only
be switched on after all the required connections are in place.
Use the supplied power cable to connect the device to the 230 V mains.
Use the supplied speaker cables to connect the active speaker to the passive
speaker. When using other cables, a suitable cross-section of the conductor must
be ensured for lengths ranging between 3 - 5 m. We hereby recommend 2.5 mm².
Avoid frayed cable ends since these might cause short-circuits if they come in
contact with the back of the speaker, which could in turn damage the amplifier.
