Instruction leaflet
Motion LED Wall
73716, 73717
www.saxbylighting.com
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting. BH23 3PE
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Do not clean the product with a pressure washer.
This LED is protected by a shade. This part must be replaced immediately should the shade become
cracked or damaged. This fitting must not be used without the shade in place.
Iss.2 21072017
• The LED Module in this product is non replaceable
Fitting/replacing bulb
PIR Adjustment
1. The unit must be installed in a vertical position, and
fitted 1.8m - 2.5m above the ground.
2. The PIR sensor is set to 10 metres. The detection
angle is set at 110 degrees. The duration that the lamp
stays on can also be altered from (10±5) seconds
to (4±1) minutes. Use a small screwdriver to adjust
the ‘TIME’ and ‘LUX’ screws. When adjusting the
sensitivity (detection distance) in daylight it will be
necessary to cover the sensor to simulate night time.
