Starting Up
The system is performing self-checks and energizing
the brake system. This code should clear within 15
seconds after you turn on the power switch. If the
ambient temperature is very low (below about 0°
F), this code may take longer to clear. The safety
system detects such low temperatures within the
brake cartridge. If necessary, the system turns on a
heater inside the cartridge to raise the temperature
of the electronics. This code will continue until the
temperature inside the brake cartridge is within the
normal operating range.
Ready or Running
All self-checks have been completed, the safety
system is operating properly, and the saw is in
Standby Mode and ready to run.
Coasting Down
The blade is coasting down and that the safety system
is ready to activate the brake if contact is detected.
The safety system monitors the rotation of the blade
while it is coasting down. If you touch the blade while
this code is flashing, the brake will activate.
Switchbox Error
Both lights flash slowly together (synchronized). This
code indicates an error with the electrical system.
The error is not user-serviceable—contact SawStop
Service for assistance (
How to Set the Rip Width
Understand the difference between rip cuts and cross
cuts before cutting (
).
to learn how to place the rip fence on
the mounting lugs.
1. Pull the rip width control to unlock the rail
mechanism.
2. Turn the control to adjust the width. Look directly
down on the lens position indicator (A) and the
ruler to determine the rip width.
See the following section to learn how use the ruler.
3. Push in the control to lock the mechanism.
How to Use the Ruler
When you mount the rip fence on the lugs closest to
and to the right of the blade (A), use the upper scale
(B) on the ruler.
to learn how to use the low fence.
A
1
1
1
1
1
4
3
1
0
9
8
7
6
5
4
3
2
1
0
2
2
1
1
1
1
1
9
8
6
5
7
0
4
3
2
1
0
B
A
22
|
SawStop
®
Compact Table Saw
