Page 21
Part No. 000823, 06-m02-2012
OMEGA IPL Installation Guide
Step 11
Install control cams (if required)
Install the control cams (if required).
Procedure
NOTE
The control cams are normally pre-mounted. Follow the
steps below if they are not already mounted.
1
Mount the control cams on the profiles between the
upper and centre rail tubes in the area of the platform
stop positions. Mount the cams according to the
description on the plan drawings. In some cases, it may
be necessary to release both arms at the lower stop
position. In this situation, use two control cams (as
shown in the photo below).
WARNING
Never mount two control cams at the upper stop position;
this could cause the lower arm to open and the passenger
could fall off the platform!
Figure 54
Control cam
Control cam
Figure 55
Lower control cam (with two cams)
Figure 56
Upper or intermediate control cam
2
Adjust the control cams according to the description on
the plan drawings. The levers for releasing the arms
(shown below) should be in the middle of the control
cam when the lift arrives at the stop position.
Figure 57
Arm release levers
NOTE
The upper lever is responsible for releasing the left arm (as
viewed from the front of the carriage); the lower lever is
responsible for the right arm. Note that this is regardless
of whether you have a left- or right-hand lift.
3
Check that the lift operates properly at each landing.
