CONTENTS
(1) SOFTBOX COVER
(1) CONNECTOR DISK
(16) CONNECTOR RODS
(1) BEAUTY DIFFUSER
(1) FRONT DIFFUSER
(1) ALUMINUM DEFLECTOR DISH
(2) DEFLECTOR DISH SPACE RODS
(1) GRID
(1) CARRY BAG
1) LAY SOFTBOX OUTER COVER ON A
LARGE FLAT SURFACE WITH SILVER SIDE UP.
ASSEMBLY
Assembly & Usage
Instructions
COLLAPSIBLE
FABRIC BEAUTY DISH
MODMASTER
™
2) PLACE THE CONNECTOR DISK INTO THE CENTER
AND ON TOP OF THE OUTER COVER WITH ALL 8
CONNECTOR HOLDERS IN THE UP POSITION.
3) SLIDE THE FIRST CONNECTOR ROD THROUGH THE LARGE
VELCRO LOOP, THE SMALL ELASTIC LOOP AND TUCK THE
SILVER TIP INTO THE VELCRO POCKET AT TOP OF SOFTBOX.
4) SLIDE THE BOTTOM OF THE CONNECTOR
ROD INTO A CONNECTOR HOLDER.
5) ALLOW THE CONNECTOR HOLDER TO
PIVOT UNTIL IT IS FLAT ON THE SURFACE
AND LOCKED.
6) REPEAT STEPS 3,4 AND 5, ATTACHING ALL RODS WITHOUT
SKIPPING ANY SPACES. CONTINUE UNTIL ALL RODS
ARE ATTACHED AND LOCKED IN PLACE.
ASSEMBLY CAN BEGIN AT ANY POINT INSIDE THE
SOFTBOX COVER AND WITH ANY CONNECTOR PORT.
TOTAL ASSEMBLY TIME IS APPROXIMATELY 9 MINUTES.
TO COLLAPSE THE BOX:
• START WITH ONE ROD AND PRESS DOWN TOWARDS THE SOFTBOX COVER AND THEN PULL THE CONNECTOR PORT OUT AND AWAY FROM THE
CENTER OF THE RING WITHOUT RELEASING PRESSURE. THE ROD WILL RELEASE.
• REPEAT THE ABOVE STEP UNTIL ALL 16 RODS HAVE BEEN RELEASED. THE CARRY BAG HAS BEEN DESIGNED SO THAT THE BEAUTY DISH CAN BE
LEFT IN THE BAG PARTIALLY ASSEMBLED IF YOU PREFER. YOU CAN LEAVE THE SOFTBOX JUST AS IT HAS BEEN COLLAPSED AND IT WILL FIT IN THE
CENTER SECTION OF THE BAG WITHOUT FURTHER DISASSEMBLY.
• SOME RODS MAY SEPARATE FROM THE CONNECTOR PORTS DURING STORAGE. SOME MINOR RE-ASSEMBLY MAY BE REQUIRED BEFORE THE
NEXT SHOOT WHEN PACKED IN THIS WAY.
• RODS MAY SEPARATE FROM THE CONNECTOR PORTS DURING STORAGE AND WILL REQUIRE REASSEMBLY UPON UNPACKING.
