Sav SAV 531.42, Operating Instructions Manual

Page: 95 / 112

EN
7 OPERATION
NOTE!
To switch off the lifting magnet, the lifting eye had to be lifted and lowered
again (this opens and closes the safety switch).
When handling starts (disconnecting of the safety switch underneath the lifting eye), the green READY indicator
light is on continuously.
Switching off the lifting magnet with automatic demagnetising
■
When handling has been completed, place the lifting magnet on a solid, horizontal surface again.
■
The lifting eye switches the safety switch and the lifting magnet can be switched off (the green READY indicator
light flashes).
■
Press and hold the red OFF button on the front panel of the lifting magnet (2 s).
■
The lifting magnet executes a demagnetising cycle (the red DANGER indicator light comes on), the cycle end is
indicated with an acoustic signal and the lifting magnet is switched off.
The actual demagnetising cycle
■
When the lifting magnet is switched off, press and hold the red OFF button (2 s). This only initiates the demag-
netising cycle (the function is provided for better demagnetising of the load).
Display of the battery state of charge (only on the panel)
■
On the switched-off lifting magnet, press the green ON button and immediately release it again – the battery
state of charge is displayed on the panel.
7.2.3 Using the remote control
The remote control uses infrared (IR) to send commands to the lifting magnet.
Fig. 11: Remote control
For the correct function, direct the transmitter of the remote control towards the display panel of the lifting magnet
and keep it in this position when sending commands.
CAUTION!
CAUTION!
If visual contact between the remote control and the display panel is lost
(concealed or redirected), the transmission will be interrupted.
SAV 531.42
Version 1.0
[
95
]