11
110365 • Rev A • Mar 2007
PLUS+1 GUIDE
DP200 Graphical Terminals
Operating Considerations
• Disconnect your machine’s battery power before connecting power and signal
cables to the DP200.
• Before doing any electrical welding on your machine, disconnect all power and
signal cable cables connected to the DP200
• Do not exceed the DP200 power supply voltage ratings. Using higher voltages may
damage the DP200 and can create a fire or electrical shock hazard.
• Do not use or store the DP200 where flammable gases or chemicals are present.
Using or storing the DP200 where flammable gases or chemicals are present may
cause an explosion.
• Software configures the keypad buttons on the DP200. Do not use these buttons to
implement critical safety features. Use separate mechanical switches to implement
critical safety features such as emergency stops.
• Design systems that use the DP200 so that a communication error or failure between
the DP200 and other units cannot cause a malfunction that might injure people or
damage material.
• The protective glass over the DP200 display screen will break if hit with a hard or
heavy object. Install the DP200 to reduce the possibility of it being hit by hard or
heavy objects.
• If you break the protective glass of the DP200 screen, remove the
DP200 and immediately return it to Sauer-Danfoss for service.
• Storing or operating a DP200 in an environment that exceeds the DP200 specified
temperature or humidity rating may damage the DP200.
• Always clean the DP200 with a soft, damp cloth. Use a mild dishwashing detergent
as needed. To avoid scratching and discoloring the DP200, do not use abrasive pads,
scouring powders, or solvents such as alcohol, benzene, or paint thinner.
• The DP200 is not user serviceable. Return the DP200 to the factory in case of failure.
APPLICATION
AND OPERATING
CONSIDERATIONS
