SATO S84NX, Operator'S Manual, Page: 154 / 588

[Speed]
154
• If [Protocol] in the [Applications] menu is changed to [SZPL], then [Auto Measure] is
enabled and executes automatically.
[Printing Mode]
Set whether to print using a ribbon or direct thermal media.
Available only for the combined direct thermal/thermal transfer model.
The options are as follows:
Use Ribbon
Print using a ribbon.
Direct Thermal
Print using direct thermal media.
[Ribbon Near End]
Set whether to detect ribbon near end when the ribbon is nearing the end.
When this setting is enabled and a ribbon near end is detected, this product operates as follows;
• Printing does not stop.
• The warning icon appears on the screen.
• The ribbon near end state is output to returning the product status and external signal.
Appears only if you have selected [Use Ribbon] in the [Printing Mode] menu on the combined direct
thermal/thermal transfer model.
The options are as follows:
Enabled
Enable detection of the ribbon near end.
Disabled
Disable detection of the ribbon near end.
• The warning icon is shown in the status bar on the upper part of the screen.
[Speed]
Set the print speed.
The setting range varies depending on the print resolution of the product.
The setting range of the print speed is as follows:
Resolution S84NX S86NX
203 dpi (8 dots/mm) 4 to 16 ips (inches/sec) (101.6 to
406.4 mm/sec)
4 to 14 ips (inches/sec) (101.6 to
355.6 mm/sec)