Section 3: Operation and Configuration
CW408 Operator Manual
Page 3-37
3.15 MAINTENANCE MODE
In Maintenance mode, you can further access Service mode for more printer configurations.
1.
Make sure that the power of the printer is set to off.
2.
Press the
cover open latch
on the right side of the printer to open the
top cover
of the printer.
3.
While holding down the
LINE
and
FEED
buttons simultaneously, press the power
button to set the
printer on. Release the
power button when the indicators come on.
Keep holding the
LINE
and
FEED
buttons until the printer beeps.
The printer will then enter MAINTENANCE MODE.
4.
Press the
LINE
button to select SERVICE MODE or DOWNLOAD MODE, and then press the
FEED
button
to enter to the selected mode.
Note:
FACTORY MODE is strictly for SATO authorized service personnel use. Any mis-adjustment or setting
may disrupt the performance of the printer and may cause malfunction.
Note:
In Maintenance mode, all menu screens are displayed in English only. This includes all the menu screens for
Service mode, Factory mode and Download mode.
MAINTENANCE MODE
MODE SELECT
DOWNLOAD MODE
Download
mode
Press LINE button to
select DOWNLOAD
MODE +
FEED button
MAINTENANCE MODE
MODE SELECT
FACTORY MODE
MAINTENANCE MODE
MODE SELECT
SERVICE MODE
Service mode
Press LINE button to
select SERVICE
MODE +
FEED button
DOWNLOAD MODE
DOWNLOAD READY
Open Top cover +
Press and hold LINE and
FEED b
Press Power button to on
SERVICE MODE
MENU
MACHINE SETTING
SERVICE MODE
MENU
SENSOR ADJUST
Preliminary