User Manual
London – United Kingdom
www.saten.co.uk
UAE – Dubai
Fourth Floor, 30-31 Furnival Street
JAFZA - Al Aweer
Post code: EC4A 1JQ
TEL: +97143205447
TEL: +448456769185
FAX: +97143205448
13.
PTZ:
Same as 8TUV/PTZ button on front panel.
14.
ESC:
Same as ESC button on front panel.
15.
RESERVED:
Reserved.
16.
F1:
Same as 2ABC button on front panel.
17.
PTZ CONTROL Buttons:
Buttons to adjust the iris, focus and zoom of a PTZ camera.
18.
F2 Button:
The F2 button is used to cycle through tab pages. It can also be used to enter
the Channel&OSD Position settings.
Aim the remote control at the IR receiver located at the front of the unit to test operation. If there is no
response:
1.
Using the front control panel or the mouse, go into Menu > Settings > General > More
Settings.
2.
Check and remember DVR ID#. The default ID# is 255. This ID# is valid for all IR remote
controls.
3.
Press the DEV button on the remote.
4.
Enter the DVR ID# from step 2.
5.
Press the ENTER button on the remote control.
If the Status indicator on the front panel turns green, the remote control is operating properly. If the Status
indicator does not turn green and there is still no response from the remote, please check the following:
1.
Batteries are installed correctly and the polarities of the batteries are not reversed.
2.
Batteries are fresh and not out of charge.
3.
IR receiver is not obstructed.
4.
No fluorescent lamp is used nearby.
Using a USB Mouse
A regular 3-button (Left/Right/Scroll-wheel) USB mouse can also be used with this DVR. To use a USB
mouse:
1.
Plug USB mouse into one of the USB ports on the front panel of the DVR.
2.
The mouse should automatically be detected. If in a rare case that the mouse is not
detected, please refer to the recommended device list from your provider.
The buttons on the mouse corresponds to:
1. Left Button:
•
Single-Click:
Select a component of a menu, such as a button or an input field. This is
similar to pressing the ENTER button on the remote/front panel controls.
•
Double-Click:
Switch between single screen and multi-screen mode in Preview/
Playback mode.
•
Click and Drag:
Clicking and dragging the Left mouse button can be used to control the
pan/tilt of a PTZ camera as well as to vary the position of digital zoom area and camera
