S
E
TTING
Manual Datalogger SenNet DL150 / DL151 / DL170 / DL171 / DL172
58
Satel Spain
Versión 1.01
o
Get the current IP by sending to the SIM card in the datalogger an SMS with the text
"sennet ip". You will receive an SMS with the current IP address of the datalogger.
o
Get the current IP through the sending server if the server facilitates the IP of the last
connection.
o
Use the DynDNS service. To do this you must have a DynDNS account or create it at
https://account.dyn.com/entrance
. Then, register the account in the menu
"Configuration> DynDNS". You will see a screen like this:
Contact Satel Spain or your SenNet supplier to know how to configure the datalogger depending on
the telephone operator.
The field PIN must always be filled in. If the PIN of the SIM card is not enabled (recommended),
introduce 0000 (four zeros).
It is recommended to disable the PIN, as it tends to give less connection problems.
Always introduce some value In the field "check ping". The option NO is not recommended, since the
datalogger will not check that the connection is working, so it can lead to connection failures
Figure 32. GPRS status menu
After setting the access parameters to configure the GPRS you must save changes clicking on
Configuration>
Save changes
and restart the datalogger
clicking on Reboot datalogger
at
the initial screen.
Once this is done, you should see a new button in the initial menu of the datalogger interface (button:
GPRS status).
Clicking on GPRS status you will see the signal level of the connection. For a proper operation, a value
> 10 is recommended. However, some devices can operate with lower signal levels.
Summary of Contents for SENNET DL150
Page 1: ...Dataloggers series Device network DL150 DL151 DL170 DL171 DL172 ...
Page 8: ......
Page 44: ......
Page 86: ......