SATELLINE-2ASxE
User Guide, Version 2.0
28
7.2.5 Setting the receiver status
The status of the receiver can be set in menu 5.
In simplex solutions data reception can be switched off at the transmitting part of the system. This
prevents possible external interference from preventing the data transmission.
7.2.6 Setting the repeater function
The status of the repeater function can be set in menu 6.
The radio modem can repeat short data packets (max. 135 B) using only one radio frequency. In
the repeater function the radio modem receives data in the same way as usual, but at the same
time it memorizes the received data. After finishing the reception it directly transmits the received
and memorized data on the same channel and with the same settings as received.
If addressing is
used, the message is retransmitted with the TX address corresponding to the RX address
that matched in reception i.e. if the primary RX address matched then the primary TX
address is used in the retransmission.
7.2.7 Setting the SL-command function
The status of SL-commands can be set in menu 7.
If the SL-command function is activated the radio frequency and addresses can be selected directly
from the serial port of the radio modem without connecting pin 12 to ground.
1) Set Function ON
2) Set Function OFF
Enter selection or ESC to cancel > 1
1) Set Function ON
2) Set Function OFF
Enter selection or ESC to cancel > 2
1) Set Function ON
2) Set Function OFF
Enter selection or ESC to cancel > 2
