INSTALLATION AND SERVICE INSTRUCTIONS
Models 65-080, 65-081
LED Highbay
PRECAUTION:
Before beginning installation or service, disconnect the power by turning off the circuit breaker. Turning the power off by using the light switch
is not suffi cient to prevent electrical shock. This fi xture is for indoor use and should not be used in areas of limited ventilation or high ambient
temperature. All work should be performed by a qualifi ed electrician.
IMPORTANT: This product must be installed in accordance with the applicable installation code by a person familiar with the construction and
operation of the product and the hazards involved.
INSTALLATION:
Junction Box for wiring:
1. Remove the cover plate from the junction box.
2. Connect input leads to the fi xture leads inside the J-box.
3. If fl exible conduit pipe is used, secure the pipe
on the knock-out on the J-Box cover plate.
4. Re-install the junction box cover plate.
5. Loosen the 2 screws and slide the level plate
if needed to allow the fi xture to hang straight.
Tighten the screws when the plate is positioned.
NOTE:
1. The LED driver in this unit is designed for 120-277 VAC input. No change needed to the driver wires.
2. Must screw down the safety screw located on the hook assembly to prevent the fi xture falling by accidently.
TROUBLE SHOOTING CHECKLIST: If the light does not work.
1. Check your power source.
2. Check electrical connections.
4.4"
112.5 mm
12
"
30
7 m
m
1.
9"
48
.5
m
m
5.
21
"
13
2.
5m
m
16.1"
409mm
Satco Products, Inc.,
Brentwood, NY 11717
©Copyright 2015 Satco Products, Inc. 10/15
Safety screw level plate
Placa niveladora con tornillo de seguridad
Plaque de niveau vis de sécurité
