SATA SATAjet 1000 Series, Operating Instructions Manual, Page: 45 / 60

<< Operating Instructions SATAjet 1000-110/-111/-120/-121 >> << Operating Instructions SATAjet 1000-110/-111/-120/-121 >>
EN
III.11
<< English >>
10. Troubleshooting
Malfunction Cause Corrective Action
Fluttering/spitting
spray fan or air bub-
bles appearing in the
gravity flow cup
Fluid tip has not been
properly tightened
Tighten fluid tip [2-1]
with universal spanner
[7-4]
Air distribution ring is
damaged or clogged.
Replace air distribu-
tion ring, as it will be
damaged during disas-
sembly
Air bubbles appearing
in the gravity flow cup
Loose air cap Tighten air cap [2-2]
by hand
Gap between air cap
and fluid tip ("air cir -
cuit") is clogged
Clean air circuit, ob-
serve chapter 8
Nozzle set is clogged
or damaged
Clean nozzle set,
chapter 8, or replace,
respectively, chapter
9.1
Not enough paint ma-
terial in the gravity flow
cup
Refill gravity flow cup
[1-6]
Defective paint needle
sealing
Replace the paint nee-
dle sealing, chapter
9.3
Spray pattern is too
small, crooked, lop-
sided or splitting
Clogged air cap drill-
ings
Clean air cap, observe
chapter 8
Damaged fluid tip (fluid
tip aperture)
Check if fluid tip is
damaged, replace the
nozzle set, if neces-
sary, chapter 9.1
No function of round/
flat spray control - con -
trol knob can still be
turned
Air distribution ring has
not been positioned in
correct location (pin is
not located in the drill-
ing) or damaged
Replace air distribution
ring making sure it has
been positioned cor-
rectly when inserting it,
chapter 9.2
EN-BAL-SATAjet 1000 -111 -121.indd 11 29.10.2012 12:11:07