SATA SATAjet 1000 Series, Operating Instructions Manual, Page: 40 / 60

<< Operating Instructions SATAjet 1000-110/-111/-120/-121 >>
III.6
EN
Notice!
• Ensure clean compressed air, e.g. by installing a SATA filter 100, Art.
No. 148247, outside the spray booth or a SATA filter 484, Art. No.
92320 inside the spray booth
• Use an air hose with minimum 9 mm internal diameter (see warnings),
e.g.
Art. No. 53090.
1. Check if all screws [2-1], [2-2], [2-3], [2-4] and [2-5] have been
tightened firmly. Tighten fluid tip [2-1] firmly by hand (14 Nm) accord -
ing to [7-4] . Check if locking screw [2-5] has been firmly tightened
according to [10-1] . Tighten, if necessary.
2. Rinse material passages with suitable cleaning solution [2-6] , ob-
serve chapter 8.
3. Adjust air cap: vertical spray fan [2-7] , horizontal spray fan [2-8] .
4. Insert paint strainer [2-9] and install gravity flow cup [2-10] .
5. Fill gravity flow cup (max. 20 mm below upper edge), close with the lid
[2-11] and insert anti-drip device [2-12] .
6. Screw connection nipple [2-13] onto the air inlet.
7. Connect compressed air hose [2-14] .
7.1. Adjustment of the Spray Gun Inlet Pressure
Notice!
• Fully pull trigger and adjust spray gun inlet pressure (see chapter 2)
according to one of the follwing sections [3-1], [3-2], [3-3] to [3-4] ,
then release trigger.
• With
[3-2], [3-3]
and
[3-4]
, the air micrometer
[1-13]
has to be fully
opened and in vertical position.
• If the required spray gun inlet pressure is not reached, the pressure
at the compressed air circuit has to be increased; too high pressure
results in too high trigger forces.
[3-1] SATA adam 2 (accessory / accurate method).
[3-2] Separate gauge with control device (accessory).
[3-3] Separate gauge without control device (accessory).
[3-4] Pressure regulation at the compressed air circuit
(most
inaccurate method): rule of thumb: pressure at the pressure re-
ducer must be set 0.6 bar higher than the recommended spray gun
EN-BAL-SATAjet 1000 -111 -121.indd 6 29.10.2012 12:11:06