SATA jet 1000 B, Operating Instructions Manual

Page: 421 / 435

421
US
Operating Instructions SATAjet 1000 B RP/HVLP Operating Instructions SATAjet 1000 B RP/HVLP
Malfunction Cause Corrective action
Air bubbles appearing
in the gravity flow cup
Loose air cap Tighten air cap [2-2]
by hand
Gap between air cap
and fluid tip ("air cir -
cuit") is clogged
Clean air circuit, ob-
serve chapter 8
Nozzle set is clogged
or damaged
Clean nozzle set,
chapter 8, or replace,
respectively, chapter
9.1
Not enough paint ma-
terial in the gravity flow
cup
Refill gravity flow cup
[1-6]
Defective paint needle
sealing
Replace the paint nee-
dle sealing, chapter
9.3
Spray pattern is too
small, crooked, lop-sid-
ed or splitting
Clogged air cap drill-
ings
Clean air cap, observe
chapter 8
Damaged fluid tip (fluid
tip aperture)
Check if fluid tip is
damaged, replace the
nozzle set, if neces-
sary, chapter 9.1
No function of round/
flat spray control - con -
trol knob can still be
turned
Air distribution ring has
not been positioned in
correct location (pin is
not located in the drill-
ing) or damaged
Replace air distribution
ring making sure it has
been positioned cor-
rectly when inserting it,
chapter 9.2
Round/flat spray con -
trol cannot be regu-
lated
Control has been
turned too much in
counterclockwise di-
rection; spindle has
loosend inside the
spray gun thread
Remove control with
universal spanner;
rectify or replace com-
pletely, chapter 9.6