SATA jet 1000 B, Operating Instructions Manual

Page: 419 / 435

419
US
Operating Instructions SATAjet 1000 B RP/HVLP Operating Instructions SATAjet 1000 B RP/HVLP
Information!
Check sealing surfaces inside the spray gun
[8-2]
after disassembly,
clean them, if required. Should the sealing surfaces be damaged,
please contact your SATA dealer. Align new air distribution ring by
means of the 12 o'clock marking [8-3] , (pin into drilling) and press in
with even force. Adjust material flow according to chapter 7.2 after in -
stallation.
9.3. Replacing the Paint Needle Sealing Steps:
[9-1], [9-2]
and [9-3]
When paint material leaks from the self-tensioning paint needle packing,
it needs to be replaced. Remove trigger according to [9.2] . After disas-
sembly, check if the paint needle is damaged or replace the nozzle set, if
required. Adjust material flow according to chapter 7.2 after installation.
9.4. Replacing the Air Piston, Air Piston Spring
and Air Micrometer Steps:
[10-1], [10-2] and [10-3]
Warning!
• Disconnect paint spray gun from the compressed air circuit!
When air leaks from the air cap or the air micrometer without the trigger
being pulled, these parts need to be replaced. After disassembly, grease
the air micrometer and spring with SATA high performance grease (Art.
No. 48173) , insert them together with the air piston and thighten the
locking screw [10-1] . Adjust material flow according to chapter 7.2 after
installation.
Warning!
• Check if locking screw has been firmly tightened! Air micrometer could
shoot out from the spray gun uncontrolled!