Sartorius TopMix2.Touch TM02-X, Operating Instructions Manual

Page: 6 / 41

6 Operating Instructions TopMix
Safety
Precautions
The IP protection of the TM02-X terminal/control panel and the ex-link converter YCO12-Z is IP40 as per
IEC60529. The device must be handled carefully in accordance with the IP protection rating.
The environment must be suitably secured.
The TopMix meets all requirements for electromagnetic compatibility (EMC). Interference stronger than the
maximum values specified in the standards (see Declarations of Conformity) should be avoided.
The casing on all connection cables as well as the casing on the wires inside the equipment housing are made
of PVC. Chemicals that corrode this material must be kept away from these cables.
None of the components of the TopMix should be exposed to ambient temperatures outside the range of 0°C
to 40°C during operation. Sufficient ventilation must be provided, in order to avoid excessive build-up of heat.
The equipment must only be used indoors. Avoid generating static electricity on glass and plastic parts.
The TM02-X terminal/control panel and the ex-link converter (YCO12-Z) must be connected to the
equipotential bonding conductor using a suitable low resistance method. All electrical circuits are earthed and
electrically connected to the metal parts of the device.
– The installation must be checked for correct function and safety by a trained and qualified person at
appropriate intervals (e.g. checking the cable for damage).
– Operating personnel must be trained to recognize faulty operating states and to be able to initiate the
necessary safety measures (e.g. disconnecting the ex-link converter YCO12-Z from the power supply).
Proceed with extreme caution when using pre-wired connection cables purchased from other manufacturers,
as the pin assignments may not be compatible with Sartorius equipment.
Only use cables and cable lengths approved by Sartorius.
– The operator is solely responsible when using cables not supplied by Sartorius.
The ex-link converter (YCO12-Z) should only be opened by trained personnel with the power disconnected.
Danger to life: do not touch conductive parts of the power supply wiring!
The TM02-X terminal/control panel must be installed and operated, such that the front glass panel cannot be
damaged (e.g. by falling objects). If the glass panel is damaged, disconnect the device from the power supply
immediately.
A defective device may only be repaired by trained service technicians in accordance with Sartorius guidelines.
Only original replacement parts should be used. Always ensure that the equipment is disconnected from AC
power before performing any maintenance, cleaning, or repair work.
If the equipment is opened by anyone other than persons authorized by Sartorius, all claims under the
manufacturer's warranty are forfeited. If necessary, speak to your dealer or the Sartorius Service Center.